An end-of-line test system for 100,000 boards a year, at most 30 seconds per board

We developed an automated end-of-line test system for the high-volume circuit board production of Siegenia.

POWERPROGRAMSIGNALSABCDESECTION THROUGH THE ROW OF PROBES, FIXTURE CLOSEDDETAIL Cone probe, enlargedboardprobe tipspringwirePOWERPROGRAMSIGNALSABCDESECTION THROUGH THE PROBES, FIXTURE CLOSED
  1. APressure plate
  2. BBoard under test
  3. CSpring probes
  4. DProbe plate
  5. EInstruments
Test runnerexample of a test
Board in the fixture
  1. 1Contactevery probe touches the boardPASS
  2. 2Power supplycurrent and voltages within limitsPASS
  3. 3Programmingfirmware written and verifiedPASS
  4. 4Start-upthe board starts, version readPASS
  5. 5Inputs and outputsevery channel switchesPASS
  6. 6Serial numberstored, label printedPASS

The board passes all six checks in 27.5 s. 2.5 s of the 30 s are left as reserve.

From the project: the targets of 100,000 devices a year and at most 30 s per board.
Illustration: an example test, not the project's own sequence. A run plays five times faster than real time.
Client
Siegenia
Industry
Building automation: windows, doors, ventilation
Our scope
An automated end-of-line test system for high-volume PCB production
Requirement
  • 100,000 devices a year
  • At most 30 s per board
  • TestEnd of line
  • LinePCB production

The challenge

A thorough test in at most 30 seconds

An end-of-line test is the last station on a production line. Every assembled board is checked there before it goes into a product.

At 100,000 boards a year, one second more per board adds up to almost 28 hours of testing. A fault the test misses, on the other hand, leaves the factory inside a product. So the test had to be short without leaving out a check that matters.

What we did

How a test like this stays short

A fixture presses the board onto spring-loaded probes. Instruments power the board, program it and measure it, and the test software runs the checks and decides pass or fail.

The order of the checks matters. Quick checks go first, so a faulty board is out of the fixture after a few seconds and no time is spent programming it.

Each board leaves the station with a record of what was checked and measured, and the result. A label on the board links to that record.

More about our test and production work

Test record

SN 24-117-004512

PASS

Firmware
1.4.2
Checks
6 of 6
Test time
27.5 s
Supply voltage
3.31 V
Current at rest
31 mA
Inputs and outputs
4 of 4
SN 24-117-004512FW 1.4.2EOL PASS

The code on the board's label leads to this record.

Illustration: an example record and label, not the project's.

Result

Designed for the line's volume and cycle time

100,000

Devices a year the system is designed for.

From the project

30s

Test time per board, at most.

From the project
Oleksii Kvasnikov

Oleksii Kvasnikov · Founder and lead engineer

A test station for your own production line

Tell us about the board, how many you build a year and how long each one may take.