We design circuit boards and build tested prototypes

We draw the schematic of the circuit board inside your product, lay out the board and choose every part on it. You get prototypes that we have switched on and measured, and the files a manufacturer builds from. If we also write the firmware, board and code are planned together from the start.

+5V +3V3 C1 C2 GND CAN_TX CAN_RX from the microcontroller CANH CANL to the bus R1 R2 C3 TXD RXD S CANH CANL VCC VIO GND U1 CAN TRANSCEIVER
Illustration: one page of a schematic as we draw it. Here a single chip, U1, connects a device to a CAN bus, the two-wire network used in vehicles and machines. It is an example, not a client's design.

Scope

What we take on

Every step below, or only the one you need.

We work with

  • Altium Designer
  • KiCad
  • Power supplies
  • High-speed interfaces
  • Prototypes with BOM
  • System concept

    A block diagram of the device that settles the processor, the power supply and the connections.

  • Schematic

    The complete circuit diagram of the board, in Altium Designer or KiCad, whichever your company uses.

  • Board layout

    Placement and routing, including fast data links, where the routing decides whether the board works at all.

  • Power supply

    The path from the plug or the battery to every part of the board.

  • Prototypes and parts list

    Assembled boards from a board maker, and a bill of materials (BOM) with parts that are available to buy.

  • Hardware test

    We switch the prototypes on, measure them against your requirements and correct the design.

Questions

Questions about circuit board design

Can you review a design we already have?

Yes. We review existing schematics and layouts as a job of its own, without taking on the whole design.

Who builds the prototypes?

A board manufacturer and assembler. We prepare the data, choose the parts and coordinate the order, then switch the boards on and measure them.

Which files do we get, and who owns them?

You get the original Altium Designer or KiCad project files, not only PDFs, plus the manufacturing data and the parts list. They are yours.

Do you work at a fixed price?

Yes, when the scope is written down. Otherwise we work by the hour.

Oleksii Kvasnikov

Oleksii Kvasnikov · Founder and lead engineer

A board to design from scratch, or one to review

Send the block diagram or schematic you have. If nothing is drawn yet, the requirements are enough.